Stik n Seal Extreme Conditions

Available Sizes: 0.58 fl oz (17 ml)


Color When Dry: Clear



Where to Buy


Loctite® Stik'n Seal® Extreme Conditions

Safety Precautions

Well-ventilated area, gloves.

Tools Typically Required

Applicator (e.g. small flat plastic or wooden stick.


Use between 41°F (5°C) and 104°F (40°C). Protect work area. Surfaces must be clean and free of grease, dust and other contaminants. For improved adhesion, roughen very smooth surfaces prior to cleaning. Remove cap. Puncture inner seal with reverse side of cap.


Apply thin layer of adhesive to both surfaces to be bonded and wait 3 – 4 minutes until adhesive is tacky. Carefully assemble parts, pressing both surfaces firmly together. For difficult bonds, clamp parts or use tape to hold pieces together. Do not move or use parts for at least 2 hours. Full bond strength is achieved in 24 hours. Cure times will increase with lower temperatures and humidity and if bonding two non-porous surfaces.


Clean tools and adhesive residue immediately with mineral spirits. Cured adhesive may be carefully cut away using a sharp-edged tool.