Available Sizes: 0.85 fl. oz.
Color When Dry: Translucent yellow
Where to Buy
Loctite® Epoxy Gel
Well-ventilated area, gloves.
Surfaces must be clean, dry and free from oil, wax and paint. Roughen smooth surfaces for better adhesion. Pre-fit all parts to be joined. Turn nozzle end up and pull plunger back slightly allowing air bubbles to rise to top. Remove the plug from between the piston. Cut off the end tips of the syringe. Depress the double piston to dispense equal parts of the two materials on a discardable surface. Mix resin and hardener thoroughly. Wipe syringe tips clean, retract piston slightly and close with the plug. Ensure that the plug is always placed in the same orientation on the tips.
Apply a small amount to both surfaces, join and press together. Remove any excess glue immediately with acetone. Support until bond sets in about 6 minutes at room temperature. Cooler temperatures will lengthen set and cure time.
Clean excess glue immediately with mineral spirits or acetone. Cured adhesive may be cut away with caution using a sharp blade. Prolonged immersion in paint stripper will soften the cured adhesive to aid removal.