Available Sizes: 0.85 fl. oz.
Color When Dry: Metallic Gray
Where to Buy
Loctite® Epoxy Metal / Concrete
Safety Precautions
Apply and cure in a well ventilated area. Wear gloves and wash hands after use.
Preparation
Surfaces must be clean, dry and free from oil, wax and paint. Roughen smooth surfaces for better adhesion. Pre-fit parts to be joined. Remove the plug from between the piston. Cut off the end tips of the syringe. Turn syringe end up and pull plunger back slightly allowing air bubbles to rise to top. Depress the double piston to dispense equal parts of the two materials on a disposable surface. Mix resin and hardener thoroughly until uniform in color. Wipe syringe tips clean, retract piston slightly and close with the plug. Ensure that the plug is always placed in the same orientation on the tips.
Application
Apply a small amount to both surfaces, join and press together. Remove any excess glue immediately with acetone. Support until bond sets in 5 to 12 minutes at room temperature. Usable strength in 12 hours. Full cure and strength in 24 hours.
Cleanup
Clean excess glue immediately with acetone before adhesive sets. Cured adhesive may be cut away with caution using a sharp blade. Prolonged immersion in paint stripper will soften the cured adhesive to aid removal. Use an approved hazardous waste facility for disposal.