Loctite Epoxy Plastic Bonder

Available Sizes: 0.85 fl. oz.

 

Color When Dry: Cream

 

 

Where to Buy

Within:

Loctite® Epoxy Plastic Bonder

Safety Precautions

Apply and cure in a well ventilated area. Wear gloves and wash hands after use.

Preparation

Surfaces must be clean, dry and free from oil, wax and paint. Roughen smooth surfaces with 220 grit sandpaper prior to cleaning. To clean surfaces, wipe with rubbing alcohol. Pre-fit parts to be joined. Remove the plug from between the piston. Cut off the end tips of the syringe. Turn syringe end up and pull plunger back slightly allowing air bubbles to rise to top. Press the plunger to dispel the air. Depress the double piston to dispense equal parts of the two materials on a disposable surface. Mix both components thoroughly until a uniform color is achieved. Wipe syringe tips clean, retract piston slightly and close with the plug. Ensure that the plug is always placed in the same orientation on the tips.

Application

Apply a small amount to both surfaces, join and press together. Support parts until bond sets in approximately 20 to 25 minutes at room temperature. After the fixture time is achieved the material has reached handling strength.

Cleanup

Remove any excess uncured adhesive immediately using mineral spirits, isopropyl alcohol or denatured alcohol.