Available Sizes: 10 fl. oz.
Color When Dry: White
Where to Buy
Loctite® Power Grab® Molding & Paneling Construction Adhesive
Safety Precautions
Wash hands after use.
Preparation
The temperature of the adhesive, the surfaces and the working area must be above 50°F (10°C). One surface must be porous. Surfaces must be clean, dry and free of frost, grease, dust and other contaminants. To obtain maximum adhesion, surfaces should be flat to provide adequate contact. Painted surfaces must be well-cured and free of loose paint. Sand glossy surfaces to a dull finish. Pre-fit all materials before applying adhesive. Remove nozzle. Cut the tip off the cartridge just above the threads. Replace nozzle and cut at a 45° angle to desired bead size.
Application
Apply adhesive around the perimeter 2'' (5 cm) in from the edge and vertically every 12'' (30 cm). Alternatively apply a continuous bead to all furring strips, studs and top and bottom plates. Press firmly into place within 15 minutes. Repositioning time is approximately 15 minutes, depending on bead size. Use clamps or other means of support to insure maximum contact for 24 hours or until dry. Finishing nails are required for materials that may warp such as thin wood molding and trim.
Cleanup
Clean tools and adhesive residue immediately with soapy water. Cured adhesive may be carefully cut away with a sharp-edged tool.