Tub & Tile Adhesive Caulk

Available Sizes: 5 .5 oz., 10 oz.

 

Color When Dry: Almond, White, Clear

 

 

Where to Buy

Within:

Loctite® 2 in 1™ Seal & Bond Tub & Tile

Scrub & Mildew Resistant Sealant

Safety Precautions

Apply and cure in a well-ventilated area. Wear gloves and wash hands after use.

Preparation

Apply sealant between 40°F (5°C) and 100°F (38°C). Surfaces must be clean, dry and free of old caulk, grease, dust and other contaminants. Remove mold or mildew using bleach and detergent that does not contain ammonia. Rinse surface and allow to dry. For neat bead lines, mask both sides of the joint. Cut the tip off the cartridge or squeeze tube at a 45° angle to desired bead size (minimum of 3 mm or 1/8').

Application

Using a caulking gun, apply sealant with steady pressure, forcing the sealant into the joint. Smooth bead immediately with a wet finger or a tool. Remove masking tape immediately after tooling and wipe excess off of hands and tools. Sealant is paintable with a latex or oil-based paint after 2 hours. Wait 24 to 48 hours before exposing to water.
Note: Clear sealant will extrude white and then turn to clear as it cures.

Cleanup

Clean tools and uncured product residue immediately with warm, soapy water. Cured sealant may be carefully cut away with a sharp-edged tool.