RE-NEW Silcone Caulk Renewal

Available Sizes: 3.3 fl oz

 

Color When Dry: White

 

 

Where to Buy

Within:

RE-NEW™

RE-NEW your caulk like new

Safety Precautions

Wear safety glasses and gloves and wash hands after use.

Preparation

Ensure all joints and surfaces are clean and free of grease, dust, water and other contaminants. Molded sealants should first be cleaned with mold remover then thoroughly rinsed with water. Ensure surface is dry before applying RE-NEW.

Application

Remove the cap and position the applicator at an angle (approximately 90°) to the joint so that the edges of the applicator have full contact with both faces of the joint. Squeeze out the product while moving the applicator along the joint making sure that the product is in full contact with the sealant to be coated. If unsatisfied with bead, remove product immediately with a damp cloth and apply again. In case of vertical joints, it is recommended to apply the product from the bottom up. If it is necessary, pass over the joint again without pressing. Wait 6 hours before water contact and avoid contact with cleaning agents for 24 hours after application.

Cleanup

Clean applicator with a damp cloth after use and close the cap. Cured sealant must be carefully cut away with a sharp-edged tool.