Super Glue Pen

Available Sizes: 3 g

 

Color When Dry: Clear

 

 

Where to Buy

Within:

Loctite® Super Glue Pen

Single-Drop Applicator

Safety Precautions

Well-ventilated area.

Preparation

Surfaces must be clean, dry and free from oil, wax and paint. Protect work area. Lightly roughen smooth surfaces for better adhesion. Pre-fit parts to be joined.

Application

Twist cap counterclockwise and pull off. Press tip down on firm surface to dispense glue. Apply sparingly to one surface - only one drop of adhesive per square inch of surface is required. Press parts together immediately and hold for at least 10 seconds, for best results hole for 15-30 seconds. Do not attempt to reposition the parts. Immediately after use, clean tip with tissue and replace cap. For increased strength, leave the parts undisturbed for at least 10 minutes. Full cure in 24 hours. Note: Cure time is dependent upon temperature, humidity, porosity of surfaces and amount of adhesive applied.

Cleanup

To insure non-clog tip, simply wipe with tissue and snap cap on container for safe storing. After cleaning, wet any tissue used for wiping off glue with water and dispose of. When cleaning up larger quantities of uncured adhesive, apply water and allow to cure and then scrape up. Note this may result in damage to the surfaces. Cured adhesive may be cut away with caution using a sharp blade, removed with acetone or with boiling water. Note: Acetone is highly flammable and may not be suitable for use on all materials, test surface first. Follow manufacturer’s instructions.