Loctite Plastics Bonding System

Available Sizes: Activator = 4g, Adhesive = 2g

 

Color When Dry: Clear

 

 

Where to Buy

Within:

Loctite® Plastics Bonding System

Safety Precautions

Well-ventilated area, gloves.

Preparation

Surfaces must be clean, dry and free from oil, wax and paint. Protect work area. For better adhesion, lightly roughen smooth surfaces. Pre-fit parts to be joined.

Application

Apply the surface activator to both surfaces. Wait 20 seconds for the activator to completely dry. Remove the cap and disconnect from the adhesive tube. Pierce seal of tube carefully and replace nozzle. Apply sparingly to one side only using approximately one drop per square inch of surface. Press parts together immediately. Hold in place for 30 seconds or until bond sets. Do not reposition parts. Clean tip with tissue and replace the cap.

Cleanup

Cured adhesive may be cut away with caution using a sharp blade, removed with Duro® Super Glue Remover, acetone or with boiling water. Note: Acetone may damage some plastics. Test before use.